IDE for GR
kcdさん wrote said:１）回路図でJ6の1,2を反対に接続すれば、シールドボードではなく、RXを使用した4枚目のGR（ガジェットボード）ですよね？
I appreciate you for you sincere comments. I reply for your comments. R 1) Yes. You are right, but RX support web compiler, so this board could be GR(Gadget) like GR-SAKURA(RX63N), GR-KAEDE(RX64M), but about touch programming, we can’t easily implement Workbench 6 for touch key sensitivity adjustment on the Web, so RX231 was not made as GR(Gadget) as I know.
But, there could be some new idea what I do not know, so anyone who know the way, he or she hopes to do this, then GR(new Gadget series) could be made in the future. R 2) Thank you. It sounds very good and hope to use, but GR was not accepted for RX MCU not supporting web compiler. Still MUKUGE looks good. I will talk inside and RENESAS, also. R 3) There is no left pin because this board should support all the touch pin, and having many function including I2C interface with MPU-6050, and IR TX and RX, UART, speaker and SPI interface with arduino shield mode. It will be difficult to support with this all the function. If some of them is forgiven, then it will be possibile. What about your idea? R 4) The purpose of this board is providing the best touch sensitivity for hardware designer, so if using two PCB thru hole, it will degrade the sensitivity, and it increase price due to using two PCB. Even small CPU board decrease the price, but the connector and outside touch board will increase the price. In this case PCB is twice, so machine soldering should be done twice, so the manufacturing fee will go up, also. Thank you.